Nanoxia Deep Silence 4 Spécifications télécharger pdf (Page 13)

You can remove the fan by pushing away

the retaining lugs a lile bit from the fan

and then pull the fan out (picture 6B).

The dust lter can easily be pulled out,

as you can see here (picture 6C).

Please note, that the lter element must be fully inserted to guarantee the proper operaon

of the “Easy Access Panel”.

6.2 Fans in the top cover

If you want to install an addional fan at the top of the case, please remove the Nanoxia Vent-

Cover rst by removing the screws on the outside of the case.

Next, hold the fans from the inside and secure them to the top by fastening the screws from

the outside.

A case fan installed at the top of the case should exhaust air out of the case (fan rear side

facing outwards).

7. The 2-channel fan controller

The Deep Silence 4 is equipped with a stepless 2-channel fan control for up to six case fans. You

can operate up to three fans per channel.

7.1 Connecng the fans to the fan control

The fan controller is powered by a 4-pin Molex connector that is connected directly to the

power supply.

The controller has two channels (A and B), with each channel able to control up to three 3-pin

fans, therefore a total of six fans can be controlled.

picture 6C

picture 6B

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Nanoxia Deep Silence 4 Spécifications Page 13